MNE 446: Finite Element Method in Manuf - spring
Prerequisite: MNE 252 or equivalent
Finite element method (FEM) and its application to additive manufacturing problems. The objective of this course is to enable students to apply FEM to a wide range of engineering problems.Topics include: Introduction to the fundamentals of FEM; Applied finite element modeling and practical aspects of solid, heat transfer, time-dependent, and multiphysics coupled problems; Review of additive manufacturing processes and quality/reliability issues; FEM to predict part distortions, residual stresses, and in-service performance; Simulation-based design optimization for quality improvement.
| 2024 Spring | ||||||||
|---|---|---|---|---|---|---|---|---|
| Class# | Sct | Type | Seats | Units | ||||
| 13374 | 01 | Lecture | 20 | 3.00 | ||||
| Days | Start | End | Location | |||||
| MON TUE WED THU FRI SAT | 5:00 PM EST | 6:15 PM EST | Science & Engr 110 | |||||
| Instructor: Jun Li | Class status: O | |||||||
| Prerequisite: MNE 252 or equivalent | ||||||||
| Enrollment Section | ||||||||
| Class instruction mode: In Person | ||||||||